Moisture Proof Electronics Silicone Sealant Glue Good Adhesion And Sealing

KDW-1608 which is cured from the outside to the inside by absorbing moisture in the air. It could be used in all kinds of electronic products of thermal conductivity and adhesion. It has excellent electrical insulation property, dampproof, anticorona, the function of cushion, and good high and low temperature resistance performance, temperature resistance range is -60~+260℃. The product is non-toxic, which has excellent aging resistance performance and long service life. It could be long-term used in indoor and outdoor products of adhesion, sealing, waterproofing and insulation protection.

1. Clean the surface: clean the surface of adherend or coated object, remove rust, dirt and greasy dirt, etc. (dirt and greasy dirt would affect adhesion performance)
2. Sizing: use knife to cut the head of plastic pipe, put on long nose, extrude the adhesive on clean surface, and fix the adherend.
3. Curing: put the adhesive units in the air, whether it is completely cured is depending on the thickness. (2mm thickness, 25℃, 50% humidity, could be completely cured after 24 hours )
4. Notes: Seal and store the remaining sealant immediately after use. Remove the crust on the head when using again, which would not affect normal working.